Home / Articles / ZTE Blade V60
Repair guide ZTE Blade V60 firmware Updated 2026-07-13

ZTE Blade V60 Screen Replacement: Display Module Guide

The ZTE Blade V60 has a 6.72-inch LCD (1080 x 2400) display. If the glass is cracked or the touch has stopped responding, the fix is a full display-module swap. This guide covers reaching and replacing it the way the teardown reference describes.

What you are replacing

On the ZTE Blade V60 the display module is bonded to the front cover and connects to the mainboard through the display FPC ribbon. You disconnect that ribbon, separate the module and fit the new one.

Replacement steps

  1. Open the phone: remove the card tray, release the battery cover and the 17 screws on the middle frame (full order in the teardown guide).
  2. Disconnect the battery from the mainboard first for safety.
  3. Disconnect the LCD/display FPC (and the touch-panel FPC where separate) from the mainboard.
  4. Warm the edges to soften the display adhesive, then separate the old display module from the front cover with a plastic tool.
  5. Fit the new display module, route and reconnect the display FPC to the mainboard.
  6. Reconnect the battery last, reassemble and test.

💡 After a screen repair, run camera calibration (*#*#83788#*#*) so autofocus stays correct.

⬇️ Need the software? Download official ZTE Blade V60 stock firmware free on ROM Palace — direct links, no waiting queue.

Frequently asked questions

What screen does the ZTE Blade V60 use?

A 6.72-inch LCD (1080 x 2400) panel. Replacement is a full display module bonded to the front cover.

Will the touchscreen work after a ZTE Blade V60 screen swap?

It should. Verify touch, display and keys with the engineering function test before you close the phone.

More ZTE Blade V60 guides